This new Paragon Janus-series kiln can fire both POTTERY and GLASS because the heating elements are mounted in both the top and sidewalls!

Select between pottery and glass with the flip of a switch. With the switch in the pottery position, heat comes from only the sidewall elements. With the switch in the glass position, heat comes from the top element  and the middle sidewall element.

Sentry 2.0 digital controller    includes two modes: Cone-Fire with programmed slow cooling and 18-Segment Ramp-Hold

In the glass mode, fuse and sag large glass projects placed on a single shelf. In the pottery mode, fire to cone 10 (2350°F). You can also fire several shelves of smaller glass pieces using the pottery mode.

The element in the lid/roof are mounted in a firebrick “ball” groove that eliminates element pins. The element coils are wider than the groove opening, so the elements stay in place without pins. The groove dissipates heat efficiently.

Suggested Optional items- Orton Vent Master 120V- HIGHLY RECOMMEMDED ON THIS KILN (Installed after the kiln is set up) The patented Orton Vent Master not only vents fumes but also improves firing results. It pulls fresh oxygen into the kiln for brighter colors, especially notice   Shelf Kit includes:Two 15" full round shelves, one 15" half shelf, 3 each 1/2", 1", 2", 4" and 6" square posts + one lb. of kiln wash